Call US 1-800-569-8411

Hubba HP

by MSR
Hubba HP
SKU: MSR-12445


Hubba HP

1 person, 3 season tent

MSRs ultimate freestanding shelter, this solo tent weighs less than the Hubba, yet offers increased protection.

$ 349.95

Out of stock US retailers are prohibited from shipping MSR products to addresses outside of the USA.
Hubba HP Specifications
Capacity: 1
Minimum Weight: 2.6 lbs (1.18 kg)
Floor Area: 17 sq ft (1.6 sq m)
Vestibule Area: 9.5 sq ft (0.9 sq m)
Interior Height: 40" (100 cm)
Fly Fabric 20D × 330T Ripstop Nylon 66
1000 mm polyurethane & silicone coated
Canopy Fabric 20D × 330T Ripstop Nylon 66
20D polyester mesh
Floor Fabric 40D × 238T Ripstop Nylon 6
10,000 mm polyurethane coated
MSR Hubba HP with rainfly

Hubba HP Features
MSR Hubba HP
Hubba HP with rainfly.
  • Ultralight: New technical fabric shaves ounces and provides more protection from snow, sand, and wind.
  • Livable: Unique pole configuration provides maximum interior space, a StayDry™ entrance, and large vestibule for gear storage.
  • Quick and Easy Setup: Allin- one hub-and-swivel pole design is strong and simple to use.
  • Versatile: Can be used as a double-wall tent for full protection or in 2 freestanding tarp-shelter modes: with optional footprint, or just the fly and poles only for the ultimate in weight savings.
Hubba HP Additional Photos
MSR Hubba HP MSR Hubba HP
MSR Hubba Hp with 6'2" model. Front view of the Hubba HP. This is the only door for entry into tent.
MSR Hubba HP MSR Hubba HP
Side view of the Hubba HP tent. The opposite side looks identical to this side. Rear of the Hubba HP. There is no door on this side of the tent. Mesh window seen above is always open and there is an identical mesh window on the front of the tent as well (see image above).
MSR Hubba HP MSR Hubba HP
Front door of the Hubba HP fully open with a standard 20" × 72" sleeping pad inside. Hubba HP with 6'2" model sitting inside.
MSR Hubba HP MSR Hubba HP
Mesh top of the Hubba HP. Models' hand is in the interior of the tent above the included mesh attic. One of two mesh pockets in the interior back wall of the Hubba HP.
MSR Hubba HP MSR Hubba HP
Front of the Hubba HP with full coverage rainfly. Side view of the Hubba HP with rainfly. Right side of fly features the extended vestibule area.
MSR Hubba HP MSR Hubba HP
Rear of the Hubba HP with rainfly. The rear of the fly features a vent located about 10" above MSR logo in the image above. Vent is only accessible from the outside if the tent. Part of the vestibule of the Hubba HP tent with a sized 12 pair of sneakers. Vestibule is triangular in shape and extends a little more to the left than the picture above shows.
MSR Hubba HP MSR Hubba HP
Rainfly vestibule door open. Fly door can be set to open on the left or the right (as it is above) . Rainfly of the Hubba HP with both vestibule doors tied back.