Princeton Tec
EOS Headlamp

1 watt Maxbright Rebel L.E.D.

Angle of housing adjustment.

Recognizing that different amounts of light are needed for different conditions and situations, the EOS is equipped with (3) brightness levels and a blinking emergency/signaling mode. Each level provides true current regulation ensuring that the EOS will remain at constant brightness as long as the batteries have sufficient voltage.

Angle adjustment: The LED housing can be adjusted to cast light forward or down (or any angle in between).

On/off switch: The EOS is controlled by an electronic switch at the top of the LED housing unit that provides four different operating modes. The high power mode is selected by pressing and releasing the button. Other modes can be selected by pressing and releasing the button within one and a half seconds of the first button press. The available modes, in order, are high power, medium power, low power, blinking, and off. Regardless of the operating mode selected, the EOS will turn off with one button press if more than two seconds have elapsed since the previous button press.

Hat band adjustment: The single strap can be adjusted to accomodate a wide range of sizes for bare-heads or helmets.

Water Resistant: Although the EOS is water resistant, water can get on the circuit board if the case is not properly closed. If the circuit board gets wet, remove the batteries and shake out the excess water. The circuit board is very durable and will normally resume working once the water is shaken off. After shaking off excess water, it is recommended to leave the case open to allow the inside to thoroughly dry.

Warranty: Lifetime.  Warranted to be free from defects in material and workmanship. Warranty does not cover bulbs and batteries.  Not warranted against normal wear and tear, improper use, or improper maintenance.

Housing with battery case open.