Andromeda tent
Exped Andromeda:
additional photos of interior
|
|
 |
|
| Exped Andromeda shown with 5'11" model entering the door to the vestibule. |
Exped Andromeda shown with 5'11" model inside vestibule area. The red internal guy lines that run along the ground hold the tension between the poles. |
|
|
|
 |
|
| 5'11" model shown inside the rainfly of the Exped Andromeda. Model is crouching in area where the inner tent would attach to the outer rainfly. Vent at rear of tent is open and mesh panel in vent is partially open. | Photo of vestibule taken from inside inner tent of Exped Andromeda. Door is on right side of photo, and the end vent is shown closed from inside rainfly. | |
 |
 |
|
| At the back of the inner tent, the vent lines up with vent on outer rainfly (shown in picture above) which allows occupants to open both layers of the Exped Andromeda from within the inner tent. The vents in both the inner tent and outer rainfly include a solid fabric panel and a mesh panel. | View of vent at back of inner tent with all four mesh and fabric panels open.The attached vertical support bar is held in place by hook and loop fastener on the exterior of the rainfly.. | |
 |
||
| Detailed view of stake point at edge of front door showing internal guy lines and adjustable tensioners which help the Exped Andromeda hold its shape and pull the rainfly taunt to the ground. | ||
